Ma poate ajuta cineva cu setarile BIOS?
Am urmatorul sistem:
Motherboard: EVGA X58 3x SLI Classified
CPU: Intel Core i7 975 Extreme 3.33GHz
Memory: Corsair 12 GB DDR3 2000MHz CL8 DominatorGT Triple Channel Kits (6 x 2GB Memory Modules)
Graphics Card: Leadtek WinFast GTX 295 v2
Hard disks: 2 x Western Digital 300GB SATA-II 10000 rpm 16MB VelociRaptor
Power Supply: Enermax ERV1250EGT 1250W

Imi trebuie setarile pentru:
Onboard PATA/SATA device,
Power Management Setup,
PnP/PCI Configurations,
Frequency/Voltage Control,
Memory Feature,
Voltage Control,
CPU Feature.


---------- Post added 25-02-2010 at 10:12 ---------- Previous post was 24-02-2010 at 13:31 ----------

Mother Board ( EVGA X58 Classified 141-BL-E760-A1 )
CPU ( Intel Core i7 975 Extreme 3.33GHz )
CPU Cooler ( Stock )
Memory ( Corsair 12 GB DDR3 2000MHz CL8 DominatorGT Triple Channel Kits (6 x 2GB Memory Modules) (2 x CMG6GX3M3A2000C8) )
Power Supply ( Enermax ERV1250EGT 1250W )
Graphics Card ( Leadtek WinFast GTX 295 v2 )
Sound Card ( Creative X-Fi Titanium Fatal1ty Champion )
Operating System ( Windows 7 64 Ultimate )

Standard CMOS Features:
Date:
Time:
SATA 0: Asus DRW-20B1LT
SATA 2: WDC WD5001AALS-00L3B
SATA 1: WDC WD3000HLFS-01G6U
SATA 3: None
SATA 4: None
SATA 5: None
Halt On: All Errors

Advanced BIOS Features:
Hard Disk Boot Priority:
CD-ROM Boot Priority:
First Boot Device: CDROM
Second Boot Device: Hard Disk
Third Boot Device: Removable
Boot Other Device: Enabled
Boot Up NumLock Status: On
Security Option: Setup
Full Screen LOGO Show: Enabled

Onboard PATA/SATA Device:
SATA Mode:
LEGACY Mode Support:
JMB362 SATA Controller:
JMB363 SATA/PATA Controller :
JMB363 Mode:
JMB362 Mode:

Onboard Device:
Realtek GigaLan (LAN1): Auto
Realtek GigaLan (LAN2): Auto
PE4 Slot (PCIE x1): Auto
Realtek Lan PXE Boot ROM:
TI 1394 Setting:
High Definition Audio:
P80 Show CPU Temp: Enabled

USB Device Setting:
USB 1.0 Controller: Enabled
USB 2.0 Controller: Enabled
USB Operation Mode: High Speed
USB Keyboard Function: Enabled
USB Mouse Function: Enabled
USB Storage Function: Enabled

Powe Management Setup:
ACPI Function:
ACPI Suspend Type:
Soft-Off by PWR-BTTN:
Wake-Up by PCI card:
Resume by Alarm:
HPET Support: Enabled
HPET Mode: 64-bit mode
POWER ON Function:
PWRON After PWR-Fail:

PnP/PCI Configurations:
Init Display First:
Reset Configuration Data:
Resources Controlled By:
PCI/VGA Palette Snoop:
INIT Pin 1 Assignment:
INIT Pin 2 Assignment:
INIT Pin 3 Assignment:
INIT Pin 4 Assignment:
INIT Pin 5 Assignment:
INIT Pin 6 Assignment:
INIT Pin 7 Assignment:
INIT Pin 8 Assignment:
Reserved RC For Bridge:
Maximum Payload Size:

Frequency/Voltage Control:
Dummy O.C:
Extreme Cooling:
CPU Clock Ratio:
CPU Host Frequency:
MCH Strap:
CPU Uncore Frequency(Mhz):
CPU Clock Skew:
Spread Spectrum:
PCI Frequency(Mhz):
OC Recovery:

Memory Feature:
Memory SPD:
Memory Control Setting:
Memory Frequency:
Channel INterleave Setting:
Rank Interleave Setting:
Memory Low Gap:
tCL Setting:
tRCD Setting:
tRP Setting:
tRAS Setting:
tRFV Setting:
Command Rate:
tRRD Setting:
tFAW Setting:
tRTP Setting:
tWR Setting:

Voltage Control:
EVGA VDroop Control:
CPU VCore:
CPU VTT Voltage:
CPU PLL VCore:
IOH PLL VCore:
QPI PLL VCore:
DIMM Voltage:
DIMM DQ Vref:
IOH VCore:
IOH/ICH I/O Voltage:
ICH VCore:
VTT PWM Frequency:
CPU PWM Frequency:
CPU Impedance:
QPI Signal Compensation:

CPU Feature:
Intel SpeedStep:
CxE Function:
Execute Disable Bit:
Virtualization Technology:
Intel HT Technology:
Active Processor Cores:
QPI Control Settings:
QPI Link Fast Mode:
QPI Frequency Selection:

Este cineva pe aici care se pricepe si ma poate ajuta cu setarile?